Brand
SAFETY DATA SHEET
SECTION 1: CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
HAR Adhesive Technologies
60 South Park
Bedford, OH 44146
440-786-7185
PRODUCT INFORMATION
PRODUCT
NUMBER:
PRODUCT Synthetic resin
DESCRIPTION: General purpose
RECOMMENDED primer/paint
USES: Industrial use only
RESTRICTIONS Not Applicable
ON USE: to mixtures
CHEMICAL
FORMULA:
Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300
WR
SECTION 2: HAZARDS IDENTIFICATION
GHS Classification
Flammable Liquids: N/A
Acute Toxicity (Oral): Category 4
Inhalation (Dust): Category 1A
Eye Irritant: Category 2A
Specific target organ toxicity: Repeated exposure Category 2, kidney
Signal Word: Danger
Hazard Statements:
IF IN EYES: May cause eye irritation.
DERMAL (ACUTE): Wash with soap and water. Get medical attention if irritation develops or persists.
SKIN IRRITATION: May cause minor skin irritation.
INHALATION: This material presents a hazard if concentrations exceed threshold limit levels indicated in Section 8.
ORAL: May cause damage to organs (Kidney) through prolonged or repeated exposure if swallowed.
Precautionary Statements: Protection:
-
Do not breathe dust
-
In case of inadequate ventilation, wear respiratory protection
-
Dispose of contents in accordance with local regulations
-
Wash skin thoroughly after handling.
-
Do not eat, drink or smoke when using this product.
-
Wear protective gloves/eye protection/face protection.
This product contains crystalline silica (CS) which is considered a hazard by inhalation, IARC has classified inhalation
of CS as a carcinogen for humans (Group 1). CS is listed by NTP as a known human carcinogen. Inhalation of CS
is also a known cause of silicosis, a non-cancerous lung disease.
SECTION 3: COMPOSITION/INFORMATION ON INGREDIENTS
Chemical Family: Water Based Synthetic Polymer
Chemical CAS # CONCENTRATION OSHA PEL
Name (% by weight)
Titanium 13463- 18% 10 mg/M3
Dioxide 67-7
Diatomaceous 061790- 10% 10 mg/M3
Earth 53-2
Calcium 471-34- 6% 10 mg/M3
Carbonate 1
Crystalline 14464- <5% .025mg/M3
Silicate 46-1
Ethylene 107-21- <2% 100 mg/m3
Glycol 1
Water 7732- <50% N/A
18-5
Acrylic Mixture <30% N/A
Polymer
SECTION 4: FIRST AID MEASURES
IF IN EYES: Flush eyes with plenty of water for at least 20 minutes retracting eyelids often. Tilt the head to prevent chemical from transferring to the uncontaminated eye. Get immediate medical attention.
IF ON SKIN: Wash with soap and water. Get medical attention if irritation develops or persists.
IF VAPORS INHALED: This material does not present a hazard if inhaled. Remove individual to fresh air after an airborne exposure if any symptoms develop, as a precautionary measure.
If DUST INHALED: Remove to fresh air. Drink water to clear throat and blow nose to evacuate dust.
IF SWALLOWED: Do not induce vomiting. Seek medical attention immediately. Drink two glasses of water or milk to dilute. Do not give anything by mouth to an unconscious person. Induce vomiting as a last measure. Induced vomiting may lead to aspiration of the material into the lungs potentially causing chemical pneumonitis that may be fatal.
SECTION 5: FIRE FIGHTING MEASURES
FLASH POINT: Non-flammable
AUTOIGNITION Not established
TEMPERATURE:
LOWER EXPLOSIVE Not established
LIMIT (% in air):
UPPER EXPLOSIVE Not established
LIMIT (% in air):
EXTINGUISHING Use water spray,
MEDIA: foam, dry
chemical or
carbon dioxide.
UNUSUAL FIRE AND There is a
EXPLOSION possibility of
HAZARDS: pressure buildup
in closed
containers when
heated. Water
spray may be
used to cool the
containers.
SPECIAL FIRE Persons exposed
FIGHTING to products of
INSTRUCTIONS: combustion
should wear self-
contained
breathing
apparatus and full
protective
equipment.
HAZARDOUS Carbon dioxide,
COMBUSTION Carbon monoxide
PRODUCTS:
SECTION 6: ACCIDENTAL RELEASE MEASURES
SPECIAL No health effects
PROTECTION: expected from the
cleanup of this material
if contact can be
avoided. Follow personal
protective equipment
recommendations found
in Section 8 of this SDS.
CLEAN-UP: Dike if necessary,
contain spill with inert
absorbent and transfer
to containers for
disposal. Keep spilled
product out of sewers,
watersheds, or water
systems.
Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300
SECTION 7: HANDLING AND STORAGE
Handling: Mildly irritating material.
Avoid unnecessary
exposure.
Storage: Store in a cool, dry place.
Do not allow to freeze as
product may be damaged.
Consult the Technical Data Sheet for specific storage instructions.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
EYE Wear safety glasses
PROTECTION: with side shields when
handling this product.
Wear additional eye
protection such as
chemical splash
goggles and/or face
shield when the
possibility exists for eye
contact with splashing
or spraying liquid, or
airborne material. Have
an eye wash station
available.
SKIN Avoid skin contact by
PROTECTION: wearing chemically
resistant gloves.
GLOVES: Nitrile
RESPIRATORY No respiratory
PROTECTION: protection required
under normal
conditions of use.
NIOSH approved air
purifying respirator with
organic vapor cartridge
and dust/mist filter.
Respirators should be
selected by and used
following requirements
found in OSHA's
respirator standard (29
CFR 1910.134).
VENTILATION: No exposure limits exist
for the constituents of
this product. No
engineering controls
are likely to be required
to maintain operator
comfort under normal
conditions of use.
EXPOSURE LIMITS:
Chemical Name ACGIH EXPOSURE LIMITS
Ethylene Glycol 100mg/m³
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL STATE: Liquid
COLOR: White
ODOR: Typical Latex Paint
ODOR THRESHOLD: Not established
WEIGHT PER GALLON (lbs.): 10.8
SPECIFIC GRAVITY: ~1.3
SOLIDS (% by weight): 50 - 52
pH: Not established
BOILING POINT (deg. C): 212 - 390° F
FREEZING/MELTING POINT (deg. C): Not established
VAPOR PRESSURE (mm Hg): Not established
MAXIMUM VOC: 99.7 G/L (.86 pounds/gal)
VAPOR DENSITY: Not established
EVAPORATION RATE: Not established
OCTANOL/WATER COEFFICIENT: Not established
DECOMPOSITION TEMPERATURE: Not established
SECTION 10: STABILITY AND REACTIVITY
STABILITY: Stable under normal conditions.
CHEMICAL INCOMPATIBILITY: Not established
CONDITIONS TO AVOID: Strong Acids or Bases
HAZARDOUS POLYMERIZATION: Will not occur.
HAZARDOUS DECOMPOSITION Carbon monoxide, carbon dioxide
PRODUCTS:
SECTION 11: TOXICOLOGICAL INFORMATION
CHEMICAL NAME LD50/LC50 Rat Oral
Ethylene Glycol 6,140 mg/kg
TOXICOLOGY No additional health information available. The mixture has not been tested. The
SUMMARY: information provided is for Ethylene Glycol only.
SECTION 12: ECOLOGICAL INFORMATION
OVERVIEW: No ecological information available
SECTION 13: DISPOSAL CONSIDERATIONS
To the best of our knowledge, this product does not meet the definition of hazardous waste under the U.S. EPA Hazardous Waste Regulations 40 CFR 261. Solidify and dispose of in an approved landfill. Consult state, local or provincial authorities for more restrictive requirements.
SECTION 14: TRANSPORTATION INFORMATION
Consult Bill of Lading for transportation information.
DOT: NOT REGULATED
NO SPECIFIC HAZARDS KNOWN
SECTION 15: REGULATORY INFORMATION
INVENTORY STATUS
U.S. EPA TSCA: This product is in compliance with the Toxic
Substances Control Act's Inventory requirements.
CANADIAN CEPA This product is in compliance with the Canadian
DSL: Domestic Substance List requirements.
TSCA Section 12(b) - Export Notice Requirements: This product does not contain any TSCA 12 (b) regulated chemicals.
CERCLA REGULATED CHEMICAL: Ethylene Glycol = 1 -3 % RQ = 5,000lbs
SARA 302 EHS CHEMICALS: This product does not contain any SARA extremely hazardous chemicals.
SARA 313 CHEMICALS: Ethylene Glycol = 1 -3 % RQ = 5,000lbs
WHMIS STATUS: Unless listed below, this product is not controlled under the Canadian Workplace Hazardous Materials Information System.
European Union - REACH – Substances of Very High Concern:
We do not intentionally add any of the known chemicals to the adhesive products listed, nor are any of these chemicals intentionally added in the manufacture of the raw materials used.
Occupational Safety and Health Administration (OSHA): We do not intentionally add ≥0.1% of Regulated Toxic Metals as listed by OSHA, nor are any of these chemicals intentionally added in the manufacture of raw materials used.
SECTION 16: ADDITIONAL INFORMATION
DATE:
This Safety Data Sheet is prepared to comply with the United States Occupational Safety and Health Administration (OSHA) Hazard Communication Standard (29 CFR 1910.1200) and the Canadian Workplace Hazardous Materials Information System (WHMIS). The information and recommendations set forth herein are believed to be accurate. Because some of the information is derived from information provided to HAR Adhesive Technologies from its suppliers, and because HAR Adhesive Technologies has no control over the conditions of handling and use, HAR Adhesive Technologies makes no warranty, expressed or implied, regarding the accuracy of the data or the results to be obtained from the use thereof. The information is supplied solely for your information and consideration, and HAR Adhesive Technologies assumes no responsibility for use or reliance thereon. It is the responsibility of the user of HAR Adhesive Technologies products to comply with all applicable federal, state and local laws and regulations.
WR